Hunter 42" Builder w/3 Lights in Brushed Nickel
52106 - Hunter 42" Builder w/3 Lights in Brushed Nickel
- 3889 CFM (3.24 MPH Breeze)
- Brushed Nickel Motor w/Reversible Brazilian Cherry/Harvest Mahogany MDF Blades
- 42 Inch Blade Span | 13 Degree Pitch
- Rated For Indoors (dry rated)
- WhisperWind 153mm x 15mm
- 3 Speed Pull Chain
Starting At $129.99
Other Finishes for this Ceiling Fan
Ceiling Fan Comparison Graph
|Category||Indoor Ceiling Fan|
|Family||Builder Small Room|
|Number Of Bulbs||3|
|Air Flow CFM||3659.38|
|Air Flow Efficiency||58.55|
|Amperage||High:0.507, Medium:0.264, Low:0.173|
|Blade Finish||Brazilian Cherry/ Harvest Mahogany|
|Down Rod Included||3 & 2|
|Light Kit Included||Yes|
|Motor Fan Speed||3|
|Motor RPM||High:235, Medium:111, Low:67|
|Pull Chain Included||Yes|
|Warranty||Limited Lifetime Motor|
|Airflow Efficiency||Medium:122.02, Low:168.52|
|Electricity Use||Medium:15.8, Low:7.2|
|Fan Height Blades to Ceiling||10.92|
|Fan Height of Canopy||2.75|
|Fan Height of Motor Housing||4.34|
|Fan Height w/Lightkit||18.06|
|Fan Height w/o Lightkit||12.27|
|Fan Width of Canopy||6.5|
|Fan Width of Motor Housing||10.9|
|Light Kit Type||3 Light|
|Safety Rating Listing Agency||ETL Listed|
How does the Hunter 42" Builder w/3 Lights in Brushed Nickel Compare to the Average Ceiling Fan?
Quality Rating = 3.000000 (average is 3)
A Quality Rating of 3 is average. Fans with this rating are decent quality, but not the best. Although the Hunter 42" Builder w/3 Lights in Brushed Nickel ceiling fan will run smooth and quiet at the low and medium speeds, they may not operate as perfectly on high speed as fans rated 4 or 5 and may need more balancing during installation.
Wind Speed Factor: 3.24 MPH (average is about 3)
A Wind Speed Factor of 3.24 MPH gives this fan a Breeze Rating of 4 out of 5. This is above average when it comes to ceiling fans, so you can expect to feel a decent amount of cooling breeze from the 42" Builder w/3 Lights. Aside from Quality, which accounts for smooth quiet operation and durability, the amount of wind-chill a fan can provide to cool you off is the most important consideration.
Airflow = 3889 CFM (average is about 5,000)
3889 CFM far less than the average ceiling fan, so don't expect to feel much of a breeze from this fan unless you are are directly beneath it. We only recommended the Hunter 42" Builder w/3 Lights in Brushed Nickel for small rooms or areas where very little airflow is needed. This fan may not allow you to raise your thermostat, so do not expect to save much on your cooling bills (if you have AC).
Efficiency Rating = 71 CFM/Watt (average is about 86)
An Efficiency Rating of 71 is fairly average. Efficiency is defined by the EPA as the amount of airflow a fan produces (CFM) divided by the amount of electricity (Watts) it uses on high speed without any lights on. Efficiency is less important than Airflow because more CFMs allow you to raise your thermostat higher...which is where you will save the most energy. Efficiency becomes more important if you expect to operate several ceiling fans at the same time. (see calculator below)
Electrical Usage = 55 Watts (average is about 76)
55 Watts per hour is well below average, which is excellent because the Hunter 42" Builder w/3 Lights in Brushed Nickel will cost less to operate than the average ceiling fan. Use the calculator below to estimate just how much it will cost to operate this fan in "Your home".
Wind Speed Factor -vs- Efficiency: Wind Speed is KING! Ceiling fans can save you a lot on your energy bills if you use them properly to reduce your use of central air. Ceiling fans cool you off by creating a wind-chill effect, so the more wind speed a fan generates, the cooler it will make you feel. The cooler your ceiling fan can make you feel, the higher you can raise your AC thermostat to conserve energy without sacrificing your level of comfort. Raising your thermostat by 10 degrees can save you up to 40% on your cooling bills, but you cannot raise your thermostat by 10 degrees if you focus only on ceiling fans that use less energy rather than ones that generate higher wind speed. To put this in perspective: A typical central air system uses about 3500 Watts when it is running, so if a ceiling fan that uses 100 watts allows you to raise your thermostat a couple degrees higher than a more "efficient" fan that uses only 50 watts, the savings you will get by raising your AC thermostat a couple degrees higher is far more than the difference of 50 watts between the two fans. With that said, a ceiling fan that uses less watts yet produces higher wind speed is a win-win.
Ceiling Fan Comparison Graph
"-" means that the data was not available at the time this information was published or the manufacturer simply does not test for the data that is missing.
Operational Cost Calculator(Instructions/Details)
This label is required by the FTC to be published
by any company selling this fan on the Internet.
Yes it is
Answer this Question
It is a brushed nickel finish. Whether it is actually nickel plated, the manufacturer does not specify. But it does have a coating to preserve the finish.